Removal of heater fan of Renault Megane 2

First, carefully remove the cover. Key latch is located in the center of the panel. Pull it up.

You'll see the following picture. Then take the flashlight and reach pedals.

Remove stop light button. For this purpose turn it counterclockwise and pull out.

Remove connector from throttle pedal, while pressing its flat side. Then pull it out. It might be necessary to use screwdriver.

Then remove brake pedal. For this purpose, remove retaining washer, pull it out of the rod, lower clamp and remove pin by turning it rightward.

Using wrench 13, unscrew 4 nuts that hold pedal assembly and remove it.

Then move deeper. In the upper part you will see necessary aggregate. Disconnect one more connector and latches from the ends.

We are very close. It is very simple. Proceed as shown on photo.

Then remove the connector with two thick wires. For this purpose pull the latch from the center for the assembly. Open the connector like a boot lid. Then pull it out in leftward direction.

The most interesting part is to remove the assembly since it is blocked with brake push rod. There is no problem if you follow Renault instructions but scope of work will double. However, you can find the way out in any situation and this problem is not an exclusion. Just push it between heater tubes and brake rod. You can pull this assembly out only if motor is in certain position. The installation should be performed in reverse order.